I am running XFCE 4.10 in archlinux and today when i added couple of partitions to fstab and rebooted my system I noticed that thunar doesn't show the partitions that I added to my fstab. what should i do to make it appear in thunar ?
here is my fstab:
/dev/sda5 /media/disk ntfs-3g defaults 0 0 /dev/sda2 /media/disk-1 ntfs-3g defaults 0 0
After adding partitions to your fstab just to make sure the mount ok with the correct options if you run
sudo mount -a
this will attempt to mount all the stuff in your fstab, you will get some complaints about some stuff already mounted but ignore that and concentrate on what the new bits are that you are trying to mount, also make sure the mount points exist.
I did mount the patitions but it doesn't appear on the left panel ...
I had to craete a shortcut instead
I read in one of the threads in crunchbang forums that it has been intentionally removed from the left panel (the partitions that are automatically mounted during the startup)
You has installed the package "gvfs"?
Last edited by Clio (2012-10-05 13:55:34)
yes i have gvfs, thunar-volman installed
Thunar-volman works without fstab.
For testing, you can commented out the lines in fstab.
You know, only the user can see the devices in the left pane in thunar.
Windows-filesystems ntfs or fat needs parameters e.g. umask or uid in the fstab.
read man mount for the values.
Windows can't understand any unix parameters.
Last edited by Clio (2012-10-05 16:50:29)
if i remove the partitions from fstab it appears but when i mount it via fstab it doesn't show up for which i had to create a shortcut.
Sure... thats right.
Without volman, you need an entry in the fstab with the right parameters and a mountpoint in /media with the same name.
If you need thunar-volman, is it impossible to mount the shortcuts.
not sure if i am able to mount without thunar-volman because when i installed xfce using archwiki it asked me to and i did .
i was expecting that when I add partitions to fstab, thunar will automatically show the icons for the partitions on the left side panel but it didn't. I then had to create shortcuts for those partitions to access the partitions from the left panel.
Hi archmonk, yeah it really sucks that thunar doesnt recognise paritions defined in fstab.
I've got the very same issue and discussed it about 5 months ago in this thread:
It's pretty sad that it works perfectly in other filemanagers (PCManFM, Nautilus etc.) but not in thunar.
Last edited by nuc (2012-10-08 17:00:10)
Is there a way to remount in Thunar a USB Stick that was ejected with Eject command, but not detached from PC? It remains as /dev/sdb with the stick name on USB bus without any volume IDs.
Last edited by sambul14 (2012-10-21 12:24:51)