Panel Network Monitor

Crippled · 2016-05-20 00:48:26

I am using Manjaro running Xfce 4.12 and I put the Network Monitor in the panel and it doesn't work. When I open it up, there is nothing in the space for "Network device". What goes in the blank space of Network device?

ToZ · 2016-05-20 01:26:56

Crippled wrote:

What goes in the blank space of Network device?

The name of your network device.

ip link

...should help. Example:

$ ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp0s25: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1280 qdisc fq_codel state DOWN mode DEFAULT group default qlen 1000
    link/ether a0:2b:b8:2e:6f:f7 brd ff:ff:ff:ff:ff:ff
3: wlo1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DORMANT group default qlen 1000
    link/ether c4:d9:87:50:9b:05 brd ff:ff:ff:ff:ff:ff

...my loopback is "lo", my wired is "enp0s25" and my wireless is "wlo1".

Crippled · 2016-05-20 01:42:39

It just started working. Thanks.

ToZ · 2016-05-20 01:43:06

Yes, enp4s0.
What happens of you hover your mouse over the plugin. Do you get stats updated in the tooltip? If so, maybe its a theme issue where the colours aren't properly being displayed.

Crippled · 2016-05-20 01:45:18

It's working. It showed an error but after a while it started working. Thank you.

Xfce Forum

Sub domains

#1 2016-05-20 00:48:26

Panel Network Monitor

#2 2016-05-20 01:26:56

Re: Panel Network Monitor

#3 2016-05-20 01:42:39

Re: Panel Network Monitor

#4 2016-05-20 01:43:06

Re: Panel Network Monitor

#5 2016-05-20 01:45:18

Re: Panel Network Monitor

Board footer